There was a rash of tales about shower doors breaking for “no apparent reason” in the news not too long ago, with the worst example including a small kid being rushed to the hospital with hundreds of wounds all over his body. These events occurred not too long ago. When we think of potential hazards in bathrooms, we often consider things like sliding on water or being poisoned by chemicals stored in bottles. However, we typically do not consider the shower screen or door to be a potential hazard. Glass shower doors and enclosures aren’t without their flaws; in fact, they may be hazardous and shatter without any prior notice. There are occasions when they do it even when no one else is in the room (which is known as a spontaneous blow). To our good fortune, the federal rules in Australia mandate that any glass used for shower doors be of the tempered safety kind. This indicates that rather than breaking into huge, jagged fragments, the glass shatters into a multitude of smaller pieces as it breaks. Even while these tiny shards of non-tempered glass are obviously safer than the larger ones, it is still possible for someone to cut themselves on them. In addition, injuries might be caused by shower hardware that falls on someone. In point of fact, there are a number of Australian standards that control these spheres, and one can locate an exhaustive list of these standards on the website of the Australian Glass and Glazing Association. Although it is reassuring to know that even if a shower door does shatter, it is unlikely that you will sustain any injuries that need hospitalization, the issue of what causes shower doors to seemingly erupt without warning still needs to be answered. It was said in an article that was published by ABC News that “it turns out that their greatest strength – safety – is also their biggest vulnerability.” The process of tempering involves heating the glass, which changes the material’s tensile strength. Even while it becomes considerably stronger and is more resistant to direct contact, it gets lot weaker and is much more easily damaged by side impacts. This shattering-inducing side impact might be the consequence of a multitude of reasons, including the door being wrongly fitted, stoppers or bolts being broken, insufficient cleaning, or abuse by the owner. As a result, tempered glass that is dropped on its edge can quickly break. In addition, even minor flaws in the glass might result in the shower door shattering without any prior notice and even if no one is in the bathroom at the time. Does this imply that you shouldn’t have glass doors for your shower? certainly not. Consider the following information on precautions: Make advantage of a trained expert. It is likely going to be more expensive to have a professional install your glass shower door or screen than it would be to do it yourself. Having the work installed by a professional, on the other hand, will provide you with the peace of mind (and maybe a warranty) that the job has been completed to the best possible quality. examine your property Even though a shattered glass shower door may seem to have occurred for no apparent cause, doing routine inspections will assist you in locating any possible problems in advance of a catastrophic event. For instance, make sure that any movable panels are firmly connected, that any hardware is secure and tight, that rubber stoppers or bumpers are in place and that they are not worn out, and that glass is not broken or chipped in any way. correct use of Always put your glass shower door to use for the function it was designed for. For instance, you should not use the towel bar that is mounted on the door as a safety bar while climbing up and down the stairs. In addition, it is important that you do not slam the door or use it aggressively in any way. source It is simple to throw the finger at imported glass, and it is undeniable that Australia is being supplied with glass that does not meet the requirements set out by Australian law. This does not imply that every piece of imported glass does not meet the requirements. In point of fact, there are a lot of glass producers that make products of a high quality that are up to par with Australian requirements. Realistically speaking, there will always be a small number of producers that cut costs; nonetheless, the responsibility of ensuring compliance lies with the importer of glass into Australia. Regardless of whether the glass was produced domestically or abroad, it is required to comply with the necessary Australian standards, which in the first instance are as2208 and as4666. choice that is appropriate The proper choice of glass takes into account the span, size, position, and application of the glass, with careful considerations surrounding wind loadings, safety, and human impact hazards. The correct choice of glass also takes into account the application of the glass. Making a poor choice in the kind of glass to use is perilous and may result in severe harm. In everyday life, glass is a material that, if not handled properly, poses a risk to those who come into contact with it. When it comes to the supply chain, there are a number of essential components that have to be preserved in order to guarantee a risk-free environment in the house. Even though it could seem to be enticing at first, purchasing anything from a local hardware shop because of its inexpensive price might not be worth the risk. amac showerscreens & robes is dedicated to preserving your well-being by only using glass that conforms to the specifications established by Australia, as well as by guaranteeing that each and every shower screen is placed in an appropriate and risk-free way.
I love myBlogd
