Round desilters manufactured by Kosun are intended to remove particles with a size range of 12 to 74 microns from plant discharge slurries in an effective manner. It is much simpler to run and maintain kosun desilters, which is one reason why they have a lifespan that is more than twice as long as traditional desilters. One of the most significant benefits of kosun round desilters is the kosun 4″ hydrocyclone, which is produced by using a specifically developed eu polyurethane that has exceptional resilience to both heat and abrasion. Because of its one-of-a-kind lightweight uni-body structure, it does away with extraneous pieces and seams, which are potential sources of excessive wear. Two cones measuring four inches in diameter are produced by Kosun. These cones have differing internal geometries, with and without a ramp at the feed intake. It is possible to transform the circular pipe feed into a rectangle feed in a seamless manner. By entering the cone in a tangential manner, this rectangular ramp feed reduces the amount of turbulence that occurs in the top region of the cone, which in turn enables the solids to move away from the wall of the hydrocyclone more rapidly. In most cases, the ramp feed cone is used when the cone underflow is located above a dewatering screen. It has a capacity of 80 gallons per minute at a head capacity of 75 feet. There are ceramic inserts available for use with kosun hydrocyclones, which are designed for high duty. Desilter operation may be maintained without interruption thanks to shut-off valves installed on each cone intake. These valves allow for the removal and inspection of individual cones. if the underflow is obstructed by superfluous solids To replace the replaceable worn portion (bottom third), just remove it, clean it, and then reinstall it. the use of a.n.s.i. buttress threaded bottom portions makes the process of servicing and replacing the bottom cone part much more expedient and straightforward. A permanent snap-on or an adjustable tri-nut are the two kinds of the apex that are available to choose from. The primary purpose of the desilter is to remove hazardous materials that are between 20 and 40 microns in size from the mud. Rapid connections are made between the urethane hydrocyclones. The design of the desilter is such that it is efficient, simple to maintain, and has a long working life while maintaining consistent performance. In addition, Kosun provides a variety of solid control systems, such as desanders, portfires, decanter centrifuges, mud cleaners, gas-liquid separators, shear pumps, jet mud mixers, vacuum degassers, desilters, centrifugal pumps, mud agitators, balanced elliptical motion shakers, screens, mud guns, submersible slurry pumps, shale shakers, and so on.
I love myBlogd
Author
jackemails@gmail.com